Swisslog's Forum › Swisslog version 5.x › Error reports v
Not reading Band mode or frequency unless Transceiver control switcheds

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Not reading Band mode or frequency unless Transceiver control switcheds
03-01-2022, 10:12 PM,
#2
EA3GCV Offline
Super Moderator
******
 		Posts: 1.691
Threads: 147
Joined: May 2013
Reputation: 12
RE: Not reading Band mode or frequency unless Transceiver control switcheds
Hi Robin,

There have been a change regarding polling ICOM transceivers in this version. Please read the Transceiver control chapter, specially the "Time between two TX-QRG queries in 1/10 seconds" and the special note for ICOM. Then set this parameter according your CI-V transceive setting on your radio (0 if ON, any value higher than 1 if OFF). Probably you have it OFF in your radio and you need polling from Swisslog so set 1 or higher.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
RE: Not reading Band mode or frequency unless Transceiver control switcheds - by EA3GCV - 03-01-2022, 10:12 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)