Not reading Band mode or frequency unless Transceiver control switcheds - Printable Version +- Swisslog's Forum (https://www.swisslogforwindows.com/forum) +-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3) +--- Forum: Error reports (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=6) +--- Thread: Not reading Band mode or frequency unless Transceiver control switcheds (/showthread.php?tid=963) |
Not reading Band mode or frequency unless Transceiver control switcheds - g3tkf - 03-01-2022 Hi I've been using SwissLog (5.103) with WSJTx and N1MM and SDRConsole/Omnirig (v1) quite successfully for seveal months until recently . No recent updates or changes that I am aware of - not even Win 10 The Radio is an IC7100. I use Win4Icom to allow 5 programmes access to the radio control port - and until a few days ago everything works well. But now Swisslog has stopped receiving update information regarding frequency and mode *UNTIL* I click the Transceiver Control Green button ... then everything is good again *UNTIL* I change mode or frequency . WSJTx and N1MM will read the changes from the radio but not SL. *This issue occurs with *just* SwissLog using the radio Com port directly with no other programme running* Any help greatly appreciated ! 73 Robin G3TKF RE: Not reading Band mode or frequency unless Transceiver control switcheds - EA3GCV - 03-01-2022 Hi Robin, There have been a change regarding polling ICOM transceivers in this version. Please read the Transceiver control chapter, specially the "Time between two TX-QRG queries in 1/10 seconds" and the special note for ICOM. Then set this parameter according your CI-V transceive setting on your radio (0 if ON, any value higher than 1 if OFF). Probably you have it OFF in your radio and you need polling from Swisslog so set 1 or higher. Best 73 RE: Not reading Band mode or frequency unless Transceiver control switcheds - g3tkf - 03-01-2022 (03-01-2022, 10:12 PM)EA3GCV Wrote: Hi Robin, Thanks Jordi that was it ! Icom radio setting default was OFF... so Swisslog set now to 1 and all is well... Thanks for your prompt reply - best wishes for 2022 ! Now to see how to transfer N1MM worked stations into Swisslog (not via ADIF) as in WSJTx 73 Robin G3TKF |