Swisslog's Forum › Swisslog version 5.x › Error reports v
Not reading Band mode or frequency unless Transceiver control switcheds

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Not reading Band mode or frequency unless Transceiver control switcheds
03-01-2022, 07:32 PM,
#1
g3tkf Offline
Junior Member
**
 		Posts: 4
Threads: 1
Joined: Sep 2020
Reputation: 0
Not reading Band mode or frequency unless Transceiver control switcheds
Hi
I've been using SwissLog (5.103) with WSJTx and N1MM and SDRConsole/Omnirig (v1) quite successfully for seveal months until recently . No recent updates or changes that I am aware of - not even Win 10  Smile
The Radio is an IC7100.
I use Win4Icom to allow 5 programmes access to the radio control port - and until a few days ago everything works well.
But now Swisslog has stopped receiving update information regarding frequency and mode *UNTIL* I click the Transceiver Control Green button ... then everything is good again *UNTIL* I change mode or frequency .

WSJTx and N1MM will read the changes from the radio but not SL.

*This issue occurs with *just* SwissLog using the radio Com port directly with no other programme running*

Any help greatly appreciated !

73
Robin
G3TKF
Find
Reply


Messages In This Thread
Not reading Band mode or frequency unless Transceiver control switcheds - by g3tkf - 03-01-2022, 07:32 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)