Not reading Band mode or frequency unless Transceiver control switcheds

[g3tkf]

Hi Robin,

There have been a change regarding polling ICOM transceivers in this version. Please read the Transceiver control chapter, specially the "Time between two TX-QRG queries in 1/10 seconds" and the special note for ICOM. Then set this parameter according your CI-V transceive setting on your radio (0 if ON, any value higher than 1 if OFF). Probably you have it OFF in your radio and you need polling from Swisslog so set 1 or higher.

Best 73

Thanks Jordi that was it !  Icom radio setting default was OFF... so Swisslog set now to 1 and all is well...

Thanks for your prompt reply - best wishes for 2022 !

Now to see how to transfer N1MM worked stations into Swisslog (not via ADIF) as in WSJTx

73
Robin
G3TKF