Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
QRZ no direct access with ver 5100a
22-07-2020, 05:45 PM,
#1
QRZ no direct access with ver 5100a
Dear Jordi,

I have a little problem since I have installed new Ver. 5100a.

I enter the callsign in " entry of the QSO's " and with earlier version, I had only to push QRZ and I was immediately on QRZ.COM ( the page of the callsign ). But now I'm only on QRZ.COM

I have to click on "statistic overview" in the " callsign" and come back in the "entry of the qso's" callsign and than only I can go and push the button QRZ and the only I'm on the right callsign page of the Ham operator.

I have try all now since 2 days but I'ts not working like before, I must do this 2 steps and then it works, the first step the system isn't reading the callsign, and thats the reason he brings me not on the correct page.

I hope you understand my bad english. I can also downgrade again to the version before but I don't know where I find the older version.

Can you please help me Jordy ?

Thank you.

73, Alain LX1AX         
Reply
22-07-2020, 05:58 PM,
#2
RE: QRZ no direct access with ver 5100a
For your info Jordy, it's not for uploading QSO's because I'm doing that by the old way in adif .
I'ts only for looking in QRZ.COM with what Ham i'm speaking and some other infos.
Thank you
73, Alain LX1AX
Reply
22-07-2020, 07:17 PM,
#3
RE: QRZ no direct access with ver 5100a
Hi Alain,

Yes there is an issue. I will release 5.100b shortly but meantime I have uploaded a beta correcting this:

www.swisslogforwindows.com/Beta/SwisslV5.exe

Simply replace the EXE file located in the Swisslog folder by this one.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply
22-07-2020, 07:46 PM,
#4
RE: QRZ no direct access with ver 5100a
Thank you very much Jordi,

for your rapid help. I just replace the file. It works again.

Thank you

73, Alain LX1AX
Reply
31-07-2020, 10:36 AM,
#5
RE: QRZ no direct access with ver 5100a
Thanks Jordi, had the same problem. Fix helped solving the problem!

Marc
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)