Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
QO-100 converter qrg presentation
27-05-2020, 03:15 PM,
#1
QO-100 converter qrg presentation
Since yesterday I am QRV on satellite QO-100. The transmission set-up is as follows. Yaesu FT-991 drives an converter 70 cm > 13 cm (e.g. 432,295 MHz > 2400,295 MHz). SWLog ist connected to FT-991 and presents the 70 cm frequency, Prop mode: SAT and SAT name: QO-100. However for logging purposes and exchanging QSL cards with other programs (Club Log, Lotw etc) it is mandatory to exchange the converter TX frequency.
Is there any possibilty to change the 70 cm frequency to 13 cm during the QSO already yet? Is there any other workaround (beside manual correction in off-line mode)? Is such a feature planned?

Thank you for your help and assistance"
Kr, es vy 73
Achim Wortmann, DL1DAW
Reply
22-06-2020, 08:05 PM, (This post was last modified: 22-06-2020, 08:07 PM by EA3GCV.)
#2
RE: QO-100 converter qrg presentation
Hi Achim,

First of all sorry for the delay in my reply but you added this message in a wrong section and now I have seen your message! I will move this message to WISH LIST.

This was discussed before on this thread:

https://www.swisslogforwindows.com/forum...ransverter

Please read it and follow my suggestions. It needs some extra work but not too much.

I see there are many transverter options so first I would need to know all transverter possibilities: 
  • 28Mhz in - 144Mhz out
  • 28MHz in - 70Mhz out
  • 432MHz in - 1296 Mhz out
  • 144MHz in - 50MHz out, etc 
So all these different combinations do things harder to implement in the code to fulfill all options.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)