Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Frezing after solve End Time Problem
08-05-2019, 12:59 PM,
#1
Frezing after solve End Time Problem
After updating the swisslog.exe file because of the problem in the end time log, the software froze a few times, even when just being open but not being used.
What should I do? Any tips?

73!
PY1FR,
Fernando Rodrigues
Niterói - Rio de Janeiro
Brazil
Reply
08-05-2019, 03:30 PM,
#2
RE: Frezing after solve End Time Problem
Hello Fernando,

Please download again the Beta (in the same link). I have made some corrections to avoid this.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply
09-05-2019, 02:45 AM,
#3
RE: Frezing after solve End Time Problem
Hi Jordi,
I downloaded the new Beta, but the problem persists.
After some time the software freezes.

73!
PY1FR,
Fernando Rodrigues
Niterói - Rio de Janeiro
Brazil
Reply
09-05-2019, 02:46 PM,
#4
RE: Frezing after solve End Time Problem
Hi Jordi!
The problem does not occur using WSJT-X, only with JTDX, both in UDP mode.

73!
PY1FR,
Fernando Rodrigues
Niterói - Rio de Janeiro
Brazil
Reply
16-05-2019, 02:11 AM,
#5
RE: Frezing after solve End Time Problem
Hi Fernando,

Please download a new beta in the same link. Now it should work ok.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply
16-05-2019, 05:32 PM,
#6
RE: Frezing after solve End Time Problem
Ok Jordi, many thanks.

I will download the new beta.
73!
PY1FR,
Fernando Rodrigues
Niterói - Rio de Janeiro
Brazil
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)