Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DataBase/Tables Curiosity...
06-05-2018, 01:54 PM,
DataBase/Tables Curiosity...

I tried to find an answer in the manual for a question but I could not. Maybe a pointless question, but I would understand, so my request for help/ explanation.

When we create a new DataBse table then we have to select:
Some tables are selected  automatically from the groups we choose, however others no!

Because I am not sure about what is necessary I always choose all the 5 Groups and also all the tables in right side.

Is it correct or am I selecting unnecessary tables and so creating an embarrassment to the log?
I did not find reference in the Manual about this doubt, however I would like to see the most correct way of proceeding. In the manual just informs that we should choose, it is a little vague in my understanding.
Thanks for your comments. Best regards
73 Manuel Fernando
06-05-2018, 11:32 PM, (This post was last modified: 07-05-2018, 03:27 AM by EA3GCV.)
RE: DataBase/Tables Curiosity...
Hello Manuel,

If you want to clone your database configuration (without any QSO data) select the 5 Groups. I have detected that tables manually selected from the Table column are not exported to the new database! In fact, some tables on the list are not exportables. Also if you don't select any group an error is displayed. All these issues will be corrected in the next version. I will also rewrite the "Create new database" chapter in the Swisslog help for better understanding. Thank you for the report!

Best 73
Jordi, EA3GCV
Current developer of Swisslog

Forum Jump:

Users browsing this thread: 1 Guest(s)