Swisslog's Forum › Swisslog version 5.x › Error reports v
TRX interface- FT 991 problem

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
TRX interface- FT 991 problem
16-09-2020, 05:27 PM, (This post was last modified: 16-09-2020, 05:28 PM by EA3GCV.)
#5
EA3GCV Offline
Super Moderator
******
 		Posts: 1.689
Threads: 147
Joined: May 2013
Reputation: 12
RE: TRX interface- FT 991 problem
Hello Antonio,

I will review if the 991A needs other CAT commands different than the 991.

However I highly suggest you to use OmniRig instead of connecting your transceiver directly to Swisslog. OmniRig v1 is supported by Swisslog and WSJT-X (and JTDX) and this way you can share CAT control in both programs at the same time with no conflicts (OmniRig handles the COM communication then sends the info internally to the supported programs).

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
TRX interface- FT 991 problem - by dl1daw - 19-08-2017, 10:23 PM
RE: TRX interface- FT 991 problem - by EA3GCV - 20-08-2017, 08:59 AM
RE: TRX interface- FT 991 problem - by EA3GCV - 20-08-2017, 12:48 PM
RE: TRX interface- FT 991 problem - by EA4HBF - 16-09-2020, 10:52 AM
RE: TRX interface- FT 991 problem - by EA3GCV - 16-09-2020, 05:27 PM
RE: TRX interface- FT 991 problem - by EA3GCV - 17-09-2020, 12:55 AM
RE: TRX interface- FT 991 problem - by EA4HBF - 19-09-2020, 03:02 PM
RE: TRX interface- FT 991 problem - by EA3GCV - 20-09-2020, 08:54 PM
RE: TRX interface- FT 991 problem - by EA4HBF - 21-09-2020, 05:13 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)