TS-590S and SWL

[EA3GCV]

Hi,

For your words I understand that the CAT control works ok in Swisslog (you can change modes and frequencies) but it takes a while to read the frequency in Swisslog when you make QSY in your transceiver, isn't it? If this is true then try to use a lower baud rate, starting from 4800 and check again but it should work. The right settings should be:

Baud rate: 4800
Parity: None
Data bits: 8
Stop bits: 1
Flow control: leave all them unchecked. XON = 17 XOFF = 19

Best 73