Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MixW3 + Swisslog
29-07-2022, 09:14 PM,
#1
MixW3 + Swisslog
I get the following error.
When I start Swisslog, MixW is started immediately
But I don't want to use MixW, which I noticed
That this is only recently. I can also use the MixW connection
Do not switch off . Please does anyone have any suggestions for this
Possibly Jordi to fix
LG Eric
Reply
31-07-2022, 01:48 PM,
#2
RE: MixW3 + Swisslog
Hello,

If MixW is started when Swisslog starts is because you have configured this in Options / Digital mode interface > WSJT-X / JTDX UDP Settings. You will probably have MixW defined to Auto Start. The normal behaviour is that MixW autostart when user presses the MixW button in the QSL Entry window.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply
02-08-2022, 04:36 PM,
#3
RE: MixW3 + Swisslog
Hello Jordy!
Unfortunately, I have tried everything when I start Swisslog, MixW is always started
But in Swisslog I only have to click the button Connection with below
Switching MixW from red to green but there is no QSO after saving in MixW
Transferred to the Swisslog although is shown below on green.
Is there a possibility of vers. 104 to install an older version again
Without losing all settings.
LG Eric
Reply
02-08-2022, 08:05 PM, (This post was last modified: 02-08-2022, 08:08 PM by EA3GCV.)
#4
RE: MixW3 + Swisslog
Hello Jordi,

The solution is not install an old version but disable what you have configured to auto start MixW at the same time of Swisslog and configure correctly to save the QSO. Probably your antivirus or firewall is blocking the link between Swisslog and MixW and it's mandatory to add exceptions to MixW and Swisslog either in your antivirus and firewall. Or maybe you are running Swisslog or MixW with administrator right and BOTH programs must be executed with the same rights, (with or without) otherwise there won't be communication.

Contact me via whatsapp to arrange a remote Teamviewer session to check online your settings and fix it. My phone number is the in the contact section of the website.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply
06-09-2022, 02:32 PM,
#5
RE: MixW3 + Swisslog
Hello in the forum!
I've had a problem with Swisslog and MixW since a new installation
I'm not a newbie working with Swisslog since the Doss Ver. but it is
How bewitched. If I load SWL everything is ok then comes up with the Mixw button
Connect then the color of Ror changes to green so far everything is normal
But no call or name is displayed or stored in the SWL.
Warning new callsign and SetQSO time are displayed under Options MixW
On saving time at program path C.\Program Files(x86)\MixW\Mixw2.exe
Can Jordi help me, unfortunately I don't have any apps, but maybe there is some help.
LG from Austria OE5EKM Erich
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)