Rotor control

[JW6VDA]

Good morning, Jordi.

I will wait to do any more testing until I am physically present in the shack in the middle of next month. I just tested (without the beta) an it looks like this:
1. With the rotor configured in N1MM+Rotor.net and the N1MM+ logger, the rotor works flawlwessly.
2. Configuring the rotor interface in Swisslog (ProsistelD) the rotor works - BUT only in the session when it is configured. Exiting Swisslog and then reloading it, I have no more rotor control. Restarting the computer - several times - does not help.
3. After using the rotor control in Swisslog, the N1MM+Rotor.net programme will not connect to the rotor, and I have no rotor control. Computer restart does not help. Removing the configuration in Swisslog does not help.
4. The only thing that restores rotor control, is physically recycling the power of the rotor control box in the shack (power off and then power on)-

Because I depend on someone else physically entering the shack to do that, I will wait until I myself am physically present in a month's time.

In the mean time, enjoy your vacation and stay safe!

73 de Tom