Signal path is not displayed and others with Win 10

[DF1JC]

Hello Jordi,

thanks for the help. The signal path is displayed again. The problem was that all fields in the options were no longer checked after the update to 5.102b. I did not notice that.

The printer problem is still with SwissLog. But that doesn't bother me at the moment, as I only print very few 2m QSLs maybe 10 in a Year. At the moment, when I print a QSL, I take a screenshot from the QSL in print program and print it as a Photo on the QSL   
I think it's a problem with the printer and Win 10, although I can print everything else from all programs except the QSL program. Whereas it works fine with the Win7 computer. I don't know what the problem is, but never mind 

Finally, another question:
When I enter a callsign in the QSO entry window, it appears in green when I make a new call. This is still the case.
Until now, however, the call appeared in red if I had already worked the station on the same band and in black if I had worked the station on a different band. Now, however, the call only appears in black, no matter on which band I have worked it. The box "Warning on double QSO" and "Change colour of call sign on double QSO" is checked.

So far I have not found a way to restore the old state.

I think this is the typical computer problem.
The biggest programme error always sits in front of the monitor 

So dear Jordi, these are my current irritations. I hope you're not lying under your desk laughing about my Problems

73 Reiner