Icom 7300 CAT control does not synchronize

[EA3GCV]

Hello Mark,

I highly suggest you to use OmniRig otherwise you won't 0be able to share CAT at the same time with other applications such WSJT-X or MixW unless you use a virtual COM port with VSPE or similar. 

It works perfectly with IC-7300 but you have not attached a screenshot of your settings. Firstly it's, very important you set a fixed baud rate in your transceiver menú, not Auto. Set 19200 or 38400. In Swisslog you have to select Icom the Set the same baud rate set in your 7300, start bits 8, stop bits 1, parity None then check the RTS option otherwise it PTT will be set on all the time. Rest of options unchecked . Set tx hex address to 94 and uncheck the Scan for TX addr.

This way should work, there many Swisslog users using IC-7300 in Swisslog.

If you still have problems send me a screenshot of your settings.

Best 73