Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
error message in 5.100c
11-08-2020, 12:47 PM,
#5
RE: error message in 5.100c
Hi Jordi.

I've done a quick check by changing the transceiver interface option within Swisslog so that DX Commander does NOT start automatically - no error message.  I opened DX Commander outside Swisslog by going direct - no error message.  If I click start within Swisslog, the error message returns.  The error message is "Access violation at address 00404C50 in module SwisslV5.exe.  Read of address FFFFFFFE."  I've updated DXCommander to latest version (also run as administrator) - same result.

Reg
Sorry for the bandwidth - I couldn't find how to delete my earlier messages.


Attached Files Thumbnail(s)
   
Reply


Messages In This Thread
error message in 5.100c - by G3WPF - 10-08-2020, 11:57 AM
RE: error message in 5.100c - by EA3GCV - 10-08-2020, 12:45 PM
RE: error message in 5.100c - by G3WPF - 11-08-2020, 09:33 AM
RE: error message in 5.100c - by G3WPF - 11-08-2020, 09:41 AM
RE: error message in 5.100c - by G3WPF - 11-08-2020, 12:47 PM
RE: error message in 5.100c - by EA3GCV - 11-08-2020, 01:03 PM
RE: error message in 5.100c - by EA3GCV - 11-08-2020, 01:15 PM
RE: error message in 5.100c - by G3WPF - 12-08-2020, 11:22 AM
RE: error message in 5.100c - by EA3GCV - 13-08-2020, 10:49 AM
RE: error message in 5.100c - by G3WPF - 13-08-2020, 03:10 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)