Swisslog's Forum › Swisslog version 5.x › General discussion v
JtAlert and 10048 address already in use

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
JtAlert and 10048 address already in use
14-02-2020, 10:31 PM, (This post was last modified: 14-02-2020, 10:31 PM by EA3GCV.)
#2
EA3GCV Offline
Super Moderator
******
 		Posts: 1.687
Threads: 147
Joined: May 2013
Reputation: 12
RE: JtAlert and 10048 address already in use
Hello,

Have you followed the special instructions explained for JT ALERT users in the Swisslog help? Digital Modes interfaces > Setup > WSJT-X / JTDX / MSHV / JS8Call UDP Settings

By default 2237 UDP Port is used by WSJT and can't be shared by 2 applications at the same time. JTALERT is already reading this port that's the reason of this error message when opening Swisslog. You have to enable an option in JTALERT to rebroadcast UDP messages from WSJT-X into another UDP port (2234 by default) and set this port in Swisslog. In the special note for JT Alert users is explained in detail.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
RE: JtAlert and 10048 address already in use - by EA3GCV - 14-02-2020, 10:31 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)