Swisslog's Forum › Swisslog version 5.x › General discussion v
No more infos in DX Cluster window

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
No more infos in DX Cluster window
26-07-2018, 12:34 PM, (This post was last modified: 26-07-2018, 12:35 PM by EA3GCV.)
#9
EA3GCV Offline
Super Moderator
******
 		Posts: 1.689
Threads: 147
Joined: May 2013
Reputation: 12
RE: No more infos in DX Cluster window
Hello,

I guess it has been a Telner server temporary issue. I connect to VE7CC-1 with the Auto-Start option checked. But in the Input script I have added the following line:

/S sh/dx/20

This line forces to show last 20 DX just after connecting to the server. You can change 20 with the number of the desired spots you want to display. This is a good way to start Swisslog, auto start in the preferred Telnet Server then automatically fill out the DX message window or band map with the last DX spots. If no spots are displayed after swisslog startup, it's a sympthom that there is a problem in the Telnet Server. You can then check in the cluster server window as Erik recommends.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
No more infos in DX Cluster window - by F5PEQ - 28-04-2018, 06:29 PM
RE: No more infos in DX Cluster window - by F5PEQ - 29-04-2018, 04:45 PM
RE: No more infos in DX Cluster window - by KI7G - 25-07-2018, 09:38 AM
RE: No more infos in DX Cluster window - by KI7G - 25-07-2018, 07:51 PM
RE: No more infos in DX Cluster window - by EI4KF - 26-07-2018, 09:32 AM
RE: No more infos in DX Cluster window - by EA3GCV - 26-07-2018, 12:34 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)