Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
TS-590S and SWL
05-08-2015, 11:25 PM,
#1
TS-590S and SWL
I was using SWL with a TS-2000S which worked fb using RS-232  I have now changed to a TS-590S but have connected a USB cable and can not get SWL to follow the frequency or band changes.  Only the date change is active but I think that is following the coputer's date.

N1MM was used for one contest and it changed bands and freq. as I QSYd using the same USB cable.  I have now disabled N1MM in case there is a clash but still can not get SWL to display the freq. changes.

TS-590S baud rate set to 38400 the Kenwood software virtual port downloaded and set up for COM 4.

Anybody have experiece on this problem? Your help gladly needed.


Messages In This Thread
TS-590S and SWL - by ZS6BRZ - 05-08-2015, 11:25 PM
RE: TS-590S and SWL - by EA3GCV - 05-08-2015, 11:51 PM
RE: TS-590S and SWL - by ZS6BRZ - 11-08-2015, 10:58 PM
RE: TS-590S and SWL - by EA3GCV - 13-08-2015, 08:48 AM
RE: TS-590S and SWL - by EA3GCV - 19-08-2015, 11:35 PM
RE: TS-590S and SWL - by ZS6BRZ - 24-08-2015, 10:47 PM
RE: TS-590S and SWL - by EA3GCV - 25-08-2015, 01:28 AM
RE: TS-590S and SWL - by ZS6BRZ - 30-08-2015, 07:59 PM
RE: TS-590S and SWL - by EA3GCV - 02-09-2015, 11:44 AM
RE: TS-590S and SWL - by PG8M - 06-11-2015, 10:14 PM
RE: TS-590S and SWL - by PG8M - 08-11-2015, 08:40 PM
RE: TS-590S and SWL - by EA3GCV - 09-11-2015, 04:13 AM
RE: TS-590S and SWL - by PG8M - 09-11-2015, 08:36 PM
RE: TS-590S and SWL - by EA3GCV - 10-11-2015, 10:29 PM
RE: TS-590S and SWL - by EA3GCV - 10-11-2015, 11:49 PM
RE: TS-590S and SWL - by PG8M - 11-11-2015, 08:04 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)