Swisslog's Forum › Swisslog version 5.x › General discussion v
Interface cable

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Interface cable
04-03-2015, 01:15 PM,
#7
EA3GCV Offline
Super Moderator
******
 		Posts: 1.687
Threads: 147
Joined: May 2013
Reputation: 12
RE: Interface cable
(01-03-2015, 08:34 PM)EA5VK Wrote: I do not why but it is already working again.

Hello,

In the screenshot you sent me you have COM 9 selected not COM 11. You can raise the Baud rate to 4800 or 9600. Check this rates.

You have to disable UAC. Google "disable UAC windows 7" (or Vista or 8) to see how to do it.

I also recommend you to "force" run Swisslog as administrator. Right click on the Siwsslog desktop icon, select Properties and Compatibility then check the option "Run always as administrator". After doing this if you start Swisslog and you have to configure everything again (it shows as Demo) it's the proof that you were running Swisslog without these rights. Configure again everything but now it's working ok. 

I recommend you to do this in all programs. Running many programs without full administrator rights give a lot of problems. It's a famous trick in Windows Vista and higher operating systems.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
Interface cable - by EA5VK - 01-03-2015, 01:28 PM
RE: Interface cable - by EA3GCV - 01-03-2015, 01:38 PM
RE: Interface cable - by EA5VK - 01-03-2015, 02:18 PM
RE: Interface cable - by EA5VK - 01-03-2015, 02:29 PM
RE: Interface cable - by EA5VK - 01-03-2015, 02:46 PM
RE: Interface cable - by EA5VK - 01-03-2015, 08:34 PM
RE: Interface cable - by EA3GCV - 04-03-2015, 01:15 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)