Swisslog 5.8

[EA3GCV]

Hello Carlos:

Thank you for your report about windows 8.1 installation... I will try to test in another computer to see if I have to install it under compatibility mode too...

Regarding the rotator settings I'm not able to give you extra help! The most important data in the communication port settings are baud rate, and start and stop bits. If you can read the beam direction it seems that there is communication from the rotator. Look at the rotator manual to see the port settings parameters. Maybe you will have to test several flow control values... check the Start automatically box so that the rotator interface starts automatically whenever you start Swisslog.

Read this documentation regarding the rotator interface setting in Swisslog: http://www.swisslogforwindows.com/englis...erface.htm

Let me know if you achieve it!

Best 73