Transceiver Control shows a 0 when fldigi is started

[HB9TZU]

Good evening

Until now I used Ham Radio Deluxe for transceiver control.

This worked quite well, but with the change to Swisslog I would like to replace HAM Radio Deluxe as transceiver control.

My transceiver is a Kenwood TS-590Sg and is connected to a micro Keyer III.

Today I changed the transceiver control in Swisslog to flrig and want to use fldigi for the digital modes.

Swisslog and flrig work together.

However, when I start fldigi, only 0 appears as the frequency in the Transceiver Control window of Swisslog.
A band change via Swisslog (band map) is no longer possible. A band change in fldigi works and in the QSO
input window the mode, the band and the QRG are correctly tracked. When fldigi is terminated, the transceiver
frequency is again displayed correctly in the window.

In FLdigi I have selected flrig in the Rig Control.

Does it have to be like this?
Does anyone also use flrig for transceiver control and fldigi for digital modes. What does the configuration in flrig and fldigi look like for you?

73 de Christof
HB9TZU