QRZ no direct access with ver 5100a - Printable Version +- Swisslog's Forum (https://www.swisslogforwindows.com/forum) +-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3) +--- Forum: Error reports (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=6) +--- Thread: QRZ no direct access with ver 5100a (/showthread.php?tid=765) |
QRZ no direct access with ver 5100a - LX1AX - 22-07-2020 Dear Jordi, I have a little problem since I have installed new Ver. 5100a. I enter the callsign in " entry of the QSO's " and with earlier version, I had only to push QRZ and I was immediately on QRZ.COM ( the page of the callsign ). But now I'm only on QRZ.COM I have to click on "statistic overview" in the " callsign" and come back in the "entry of the qso's" callsign and than only I can go and push the button QRZ and the only I'm on the right callsign page of the Ham operator. I have try all now since 2 days but I'ts not working like before, I must do this 2 steps and then it works, the first step the system isn't reading the callsign, and thats the reason he brings me not on the correct page. I hope you understand my bad english. I can also downgrade again to the version before but I don't know where I find the older version. Can you please help me Jordy ? Thank you. 73, Alain LX1AX RE: QRZ no direct access with ver 5100a - LX1AX - 22-07-2020 For your info Jordy, it's not for uploading QSO's because I'm doing that by the old way in adif . I'ts only for looking in QRZ.COM with what Ham i'm speaking and some other infos. Thank you 73, Alain LX1AX RE: QRZ no direct access with ver 5100a - EA3GCV - 22-07-2020 Hi Alain, Yes there is an issue. I will release 5.100b shortly but meantime I have uploaded a beta correcting this: www.swisslogforwindows.com/Beta/SwisslV5.exe Simply replace the EXE file located in the Swisslog folder by this one. Best 73 RE: QRZ no direct access with ver 5100a - LX1AX - 22-07-2020 Thank you very much Jordi, for your rapid help. I just replace the file. It works again. Thank you 73, Alain LX1AX RE: QRZ no direct access with ver 5100a - on6cc - 31-07-2020 Thanks Jordi, had the same problem. Fix helped solving the problem! Marc |