+- Swisslog's Forum (https://www.swisslogforwindows.com/forum)
+-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3)
+--- Forum: Error reports (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=6)
+--- Thread: KH1/KH7Z too close? (/showthread.php?tid=456)
KH1/KH7Z too close? - IK6DLK - 03-07-2018
KH1/KH7Z too close?
RE: KH1/KH7Z too close? - EA3GCV - 03-07-2018
Here is working well reading from country table and setting DXCC from Club Log. Please make sure you are using the country table located in the DB folder (SWLCTRY.mdb). Maybe you are using an old country table.
Go to Tools / For experts only and / Open country table and select the one located in the DB folder.
If still have problems download the latest country table here:
https://www.swisslogforwindows.com/Download/Swlctry.zip
Unzip and copy country table in the DB folder, located where you have Swisslog installed.
Best 73
RE: KH1/KH7Z too close? - IK6DLK - 03-07-2018
I've done everything, the result does not change ... when I enter KH1 / KH7Z I'm giving this warning. As you can see in the box, the QTH-Locator is incorrect.
TNX
RE: KH1/KH7Z too close? - EA3GCV - 03-07-2018
Do you have a previous QSO with this station? if so, check the QTH locator set in the previous QSO and change it. I don't know why JO90 has been set. If you have worked before in FT8 using WSJT-X or JTDX maybe the QTH locator was not read properly.
Best 73