display statistics - Printable Version +- Swisslog's Forum (https://www.swisslogforwindows.com/forum) +-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3) +--- Forum: General discussion (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=4) +--- Thread: display statistics (/showthread.php?tid=409) |
display statistics - IK6DLK - 28-02-2018 Display statistics. In overview statistics, even if the entries are selected, they are not shown in the statistics. Photo 1 In Photo 2 DX Messages the SSB column is always empty even if the QSO in SSB are there. TNX 73 Fabrizio IK6DLK RE: display statistics - EA3GCV - 28-02-2018 Hello Fabrizio, This is a normal behaviour! As you can see these spots belongs to the CW frequency range according the defined band plan. The specific DXCC statistics in the DX message window only display the status for spots matching the frequency range for the selected mode. These spots belongs to CW so you would have to display DXCC-CW to see the status in the DX message windows. DXCC statistic will show the status for ALL spots. Best 73 |