Rig control - Kenwood - Printable Version +- Swisslog's Forum (https://www.swisslogforwindows.com/forum) +-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3) +--- Forum: Error reports (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=6) +--- Thread: Rig control - Kenwood (/showthread.php?tid=158) |
Rig control - Kenwood - DF6PW - 21-03-2015 Hi, I use the latest Swisslog version 5.9a. I have my Kenwood Transceiver connected via COM 2 and this works out fine. However, I found a minor bug. When I use RTTY (FSK) the mode is not displayed in the 'Mode' field. When I try to save the QSO a pop-up says somthing like "this field must be filled". So I have to switch i.e. to "CW", save the QSO and edit it after saving. Let me take the opportunity to thank Jordi, EA3GCV and all the hams involved in maintaining and updating Swisslog! I am really grateful for this ! Hardy, DF6PW RE: Rig control - Kenwood - EA3GCV - 21-03-2015 Hello Hardy, I will investigate and I will let you know. Please tell me what Kenwood transceiver are you using. Thank you for your report! Best 73 RE: Rig control - Kenwood - EA3GCV - 23-03-2015 Hello again, Just a quick note to tell you that I have fixed this problem ;-) Look for the next version which I'm planning to release in a few weeks. Best 73 RE: Rig control - Kenwood - DF6PW - 23-03-2015 Dear Jordi, You fixed it faster than I could reply ... I'm flabbergasted! If the info is still of interest, it is an old TS-950SDX connected through a microHAM Keyer interface. Vy 73 Hardy DF6PW |