+- Swisslog's Forum (https://www.swisslogforwindows.com/forum)
+-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3)
+--- Forum: General discussion (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=4)
+--- Thread: Transceiver interface (/showthread.php?tid=1330)
Transceiver interface - N9RU - 07-02-2026
I must be missing a step. I have two Flex radios on my network. They each have fixed IP addresses.
When I enter both radios in the transceiver interface, everything looks good. However, when I try to change radios, i see that both IP address are the same now. Whenever I change one IP address, the other one changes to that address also.I can work around it by just putting in the correct IP for the radio I want to use and clicking Start, But the other radios address will also change. Not big deal but i feel like I am doing not something to set the address right.
Thanks for any ideas.
Tom
N9RU
RE: Transceiver interface - EA3GCV - 09-02-2026
That's a good one Tom!! It's not your fault at all. Simply I didn't think that someone could have two (or more) Flex Radios connected! So I have to adapt the code to allow different IP combinations in all 8 transceivers in case one user may have 8 different Flex Radios!
I will work on it and I will let you know when I have a Beta version to test.
Thank you for the report!
RE: Transceiver interface - N9RU - 09-02-2026
Jordi, thank you, the new file works great and both radios are now easily accessible. Thanks again.
73
Tom
N9RU