+- Swisslog's Forum (https://www.swisslogforwindows.com/forum)
+-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3)
+--- Forum: Error reports (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=6)
+--- Thread: access violation (/showthread.php?tid=1122)
access violation - ON4RS - 15-09-2023
Hi,
When i startup Swisslog (latest version) i always get the following error messages and this two times.
1) access violation at adress 00B0CAA1 in module SwissiV5.exe. Read of adress 00000000
I'm using WSJT-X and Omnirig.
When i reinstall Swisslog, the same error message comes back.
Plaese can anyone give me some advise?
Thanks in advance and best 73's
Raph
RE: access violation - EA3GCV - 16-09-2023
Hi Raph,
It's VERY IMPORTANT you add exceptions to the Swisslog, OmniRig and WSJT-X folders in your antivirus. Also allow all incoming/outgoing comminication to the executables of all these programs in your antivirus.
Also use latest Swisslog beta version. Please read this thread:
https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=27
If you still have issues we should arrange a remote Teamviewer session. Contact me directly to my whatsapp. See my number in the Contact section of the website.
Best 73
RE: access violation - EA3GCV - 27-09-2023
Hi Raph,
I have also detected that the "Enable networking" option in the Options menu, if enabled, caused some errors. This is solved in the latest beta. You can use latest beta (read this thread https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=27) or disable this option because it's still under test and not working properly.
Best 73