+- Swisslog's Forum (https://www.swisslogforwindows.com/forum)
+-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3)
+--- Forum: Error reports (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=6)
+--- Thread: Swisslog acts strange after LotW/eQSL sync (/showthread.php?tid=1052)
Swisslog acts strange after LotW/eQSL sync - EA8DMF - 16-11-2022
Hi,
when I sync with LotW and eQSL and then want to select a QSO in Swisslog it is jumping to other QSOs.
I have to exit Swisslog and start again then it's working correct.
73, Rainer
RE: Swisslog acts strange after LotW/eQSL sync - EA3GCV - 16-11-2022
Hi Rainer,
This is not an issue. When you are synchronising with eQSL or LoTW you have to stop doing other things until the synch is finished. Most steps are synchronous operations and user have to not perform any other Swisslog functions at the same time. This is explained in the LotW / eQSL Support chapters in the Swisslog help.
73